Laerdal SimMan Essential - Manual (Page 22)

22 23
System Setup
CONNECTING TO AN EXISTING NETWORK
If you would like to connect your manikin and the instructor PC to an already existing network, please move the switch on the router
to the client mode, ref picture above. Please use the SimMan3G Network Configuration Tool to enable connection to an already
existing network.
WIRED OPERATION (DISABLING/ENABLING WLAN)
The wireless network may be disabled in AP mode. This can be achieved by using the SimMan3G Network Configuration Tool. When
using the manikin in environments where use of WLAN transmitters are prohibited: Contact your local service representative for
instructions on how to turn off radio transmission.
REMOVING/CHANGING ROUTER
The router may be changed or removed. Turn off the manikin before doing so.
Open the pelvis and locate the router. Remove the two
Ethernet cables and black power cable.
If you would like to operate the manikin without a router, then
attach a through-adapter between the two Ethernet cables.
If you would like to install a new router, attach the power cable
to the DC plug and the Ethernet cables back into the router
again.