Laerdal SimMan Essential - Manual (Page 48)

48
Simulation Setup
Connecting Defibrillation Adapter Plates
ADDING DEFIBRILLATION ADAPTER PLATES
The manikin torso is fitted with two stud connectors for defibrillator cables. Foam pads may be fitted around the defibrillator studs
during the session as illustrated below:
The defibrillator studs must be fitted in place before using a live defibrillator with defibrillation paddles or adhesive pads.
Press the adapter plates firmly into place.
DURING DEFIBRILLATION
A conventional defibrillator may be used on the SimMan Essential. During live defibrillation, the defibrillator and manikin may present
a shock hazard. All standard safety precautions must be taken when using the defibrillator on the manikin.
Note: Defibrillation must be performed on the defibrillator connectors only. DO NOT cover the ECG connectors
To prevent overheating during defibrillation do not exceed a defibrillation sequence of 3 shocks in 45 seconds followed by 1 minute
of CPR. After 30 minutes there must be at least 15 minutes with no shocking before starting a new sequence.
Note: Do not repeat this for more than a 4 hour period.
Caution: The manikin must not be in contact with electrically conductive surfaces or objects during defibrillation.
Caution: In hot conditions, intensive defibrillation may cause thermal shutdown of the manikin.
Special care should be taken when using the manikin fluid systems. To prevent torso skin electrode pitting, do not apply conductive gel
or conductive defibrillation pads intended for patient use.
Note: Do not defibrillate the manikin when it is OFF or if it is not functioning normally.
Note: Do not press too hard over the defibrillation adapters as this may cause arcing and pitting.
Note: Do not defibrillate the manikin without the torso skin.
A full service, including cleaning of the base board and its compartments should be performed at regular intervals.