Rocktron MultiValve - Manual (Page 47)

44
Operating the MultiValve ™
Step 8
Step 9 Use the PARAMETER ADJUST control to choose the highest value that the parameter is
not to exceed through MIDI control changes.
Turn the PARAMETER SELECT control one step clockwise to display the Upper Limit
parameter (for PA-A).
ULIM A -2
ULIM A XXX
Note: The MultiValve ™ allows you to select an upper and lower value limit which
the parameter cannot exceed. For example, if a parameter has a value
range from -
∞
to 0dB, yet you would like the range of the parameter to vary
from only -12dB to -2dB, you may set a lower limit of -12 and an upper limit
of -2 via the Upper and Lower Limit parameters. When a parameter is stored
in the Controller Assign function (Step 7), the maximum parameter value is
automatically stored as the upper limit, while the minimum value is stored as
the lower limit.
Step 10
Step 11
LLIM A - ∞
Turn the PARAMETER SELECT control one step clockwise to access the Lower Limit
parameter (for PA-A).
After selecting a value for the upper limit, press the STORE button to save it. "STORED" will
flash briefly on the display.
STORED