Rocktron MultiValve - Manual (Page 59)

56
To dump a single MultiValve preset into a sequencer
Operating the MultiValve
Note: When performing data dumps to and from the MultiValve, always perform the dump in real time
sequence mode. This will ensure that data loaded back into the MultiValve is not sent faster than
the MultiValve can receive it.
Also, make sure that the sequencer's MIDI filter is set to accept SYSX information.
Connect a standard MIDI cable from the MIDI OUT of the transmitting MultiValve to the
MIDI IN on the receiving sequencer. Step 1
Step 2 Turn the FUNCTION SELECT controls on the transmitting MultiValve until "MIDI DUMP/
LOAD" is displayed.
Step 3 Turn the PARAMETER SELECT control on the transmitting MultiValve until "BULK
DUMP/LOAD" is displayed.
MIDI DUMP/LOAD
BULK DUMP/LOAD
TRANSMITTING MULTIVALVE
TRANSMITTING MULTIVALVE
Step 4 Start the sequencer recording.
RECORD