Rocktron MultiValve - Manual (Page 70)

67
To set up the All Access for remote operation, perform these steps from the All Access SETUP program:
(See the All Access user's manual for detailed information on editing the All Access)
Step 8 Set the Operating Mode to "REMOTE".
Set the Bank Size to "5".
Reinitialize only the controller information for the instant access switches and pedals using the
All Access Controller Restore code number "231".
If the preset titles from the MultiValve are to be displayed on the All Access automatically, set
the Remote Title Number to match the Unit ID Number parameter on the MultiValve.
Step 9
Step 10
Step 11
Switch 6 Switches the EQ effect in or out.
Switch 7 Switches the Flanger effect in or out.
Switch 8 Switches the Tremolo effect in or out.
Switch 9 Switches the Pitch Shift effect in or out.
Switch 10 Switche the Phaser effects in or out.
Switch 11 Allows you to bypass the MultiValve.
Switch 12 Switches the Reverb effect in or out.
Switch 13 Switches the Chorus effect in or out.
Switch 14 Switches the Delay effect in or out.
Switch 15 Instant Tap Delay access.
Pedal 1 Controls the Volume parameter.
Switch 6 Switches the EQ effect in or out.
Switch 7 No function
Switch 8 Selects Slow or Fast Rotary speed.
Switch 9 Sends the change for Channel Switch 1.
Switch 10 Sends the change for Channel Switch 2.
Switch 11 Allows you to bypass the MultiValve.
Switch 12 Switches the Reverb effect in or out.
Switch 13 Switches the Rotary Speaker effect in or out.
Switch 14 Switches the Delay effect in or out.
Switch 15 Instant Tap Delay access.
Pedal 1 Controls the Slow Rotary speed.
Pedal 2 Controls the Volume parameter.
"Classic" Configuration "Rotary" Configuration
When operating the All Access in Remote mode with a MultiValve, switches 1-5 act as normal preset
switches, while other switches are automatically configured to perform special functions, as described below.
Operating the MultiValve