Rocktron MultiValve - Manual (Page 48)

45
Operating the MultiValve ™
Step 12
Step 13
Use the PARAMETER ADJUST control to select the lowest value which the parameter is
not to fall below through MIDI control changes.
Selecting a lower limit value that is greater than the upper limit value will invert the
response of the controller - i.e. the toe position of the expression controller will provide
the minimum value, while the heel position will provide the maximum value.
Note: Steps 1-13 can be repeated nine times for a total of 10 controllers. To exit
Controller Assign at any time, turn either the PRESET or FUNCTION SE-
LECT control. Only those changes that have been stored will be saved after
exiting the Controller Assign function.
After selecting a value for the lower limit, press the STORE button to save it. "STORED" will
flash briefly on the display.
LLIM A -12
STORED