Program changes – Rocktron MultiValve User Manual
Page 53
50
Program Changes
Step 1
To access MIDI Program Mapping, turn the FUNCTION SELECT control clockwise until
the MultiValve displays "PROGRAM CHANGES".
Program Changes allow for different MIDI program numbers to be assigned to MultiValve preset numbers. For
example, MIDI program #58 can be mapped to MultiValve preset #34. Then, when program #58 is selected from a
MIDI transmitting device (such as a Rocktron All Access foot controller), preset #34 will be recalled on the
MultiValve.
The Program Changes Map table is shipped from Rocktron at a one-to-one correspondance (i.e. MIDI program
#1 is mapped to MultiValve preset #1, 2 to 2, 3 to 3, etc.).
4,8
3,7
1
2,5,6
Step 2
Turn the PARAMETER SELECT control one step clockwise to display the current Program
Change On/Map/Off status.
PROGRAM CHANGES
PROG CHANGES
ON
Program Changes status options
ON - Execute MIDI program changes as received by a MIDI controller
MAP - Use mapping table when a program change is received
OFF - Do not execute MIDI program changes
Step 3
Turn the PARAMETER ADJUST control to select the desired Program Changes status
setting.
PROG CHANGES
MAP
Step 4
Press the STORE button to save the status selection. "STORED" will flash briefly on the
display.
STORED
Operating the MultiValve