Rocktron MultiValve - Manual (Page 58)

55
Operating the MultiValve
Step 4 Turn the PRESET control on the transmitting MultiValve to the preset that is to be dumped
into the receiving MultiValve. As the PRESET control is turned, the preset number will be
displayed in the first three characters of the display.
32 PR DUMP/LOAD
Step 5 Use the PRESET control on the receiving MultiValve to select the preset location to store the
received preset. (The preset currently stored at the selected location will be lost when the
new preset is received, therefore caution should be used when selecting a preset location.)
122 PR DUMP/LOAD
Step 6 To initiate the dump, press the STORE button on the transmitting MultiValve. The transmitting
MultiValve will display the preset number being dumped and "DUMPED". The receiving
MultiValve will display the preset location being stored to and "RECEIVING..." while it
receives and stores the preset parameters and title.
122 RECEIVING... 32 DUMPED
After all the information for the dumped preset is stored, the receiving MultiValve will display
"LOADED". The receiving MultiValve also recalls the loaded preset at this time so that it may
be verified.
122 LOADED
Note: If there is an error in transmission, the unit will display "RECEIVE ERROR".
Should this occur, check connections and try again. If other errors occur, check
the Error Messages chart in the Appendix.
RECEIVING MULTIVALVE
TRANSMITTING MULTIVALVE RECEIVING MULTIVALVE
TRANSMITTING MULTIVALVE
RECEIVING MULTIVALVE