Vortech Universal GM LSX Tuner Kits - Manual (Page 14)

P/N: 4GE020-015 v1.0, 2010-05-24
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
4
2. DAMPER & PULLEY INSTALLATION
A. Assemble the supplied ATI Super Damper
assembly as follows:
i. Insert the hub into the back of the damp-
er making sure to line up the “OFFSET
HOLE” in the hub and damper as shown
in Fig. 2A. This hole is labeled on the
damper sticker, and there is also an indi-
cator machined into both the damper and
the hub.
ii. Install the six (6) Torx T40 flat head
screws, using blue threadlocker on each,
and torque to 16 ft-lb. See Figures 2B &
2C.
NOTE: Make sure that all mating surfaces of the
parts are clean.
Fig 2A
Fig 2B
Fig 2C