Vortech Universal GM LSX Tuner Kits User Manual

Page 23

Advertising

P/N: 4GE020-015 v1.0, 2010-05-24

3. Install supplied M16 X 1/8 NPT fitting into oil

galley hole using supplied sealing washer.

Tighten fitting. See Fig 3D.

4. Install 1/8NPT to -4 90° fitting into previously

installed fitting. Clock the fitting so that it

points towards the rear of the vehicle.

Tighten fitting. See Fig 3D.

5. Install 90° end of supplied oil feed hose onto

-4 fitting. Clock oil feed line so that it points

downward. Tighten fitting. See Fig 3E.

6. Reinstall alternator and re-attach all electrical

connections. Route open end of oil feed

hose around the back of the alternator and

up toward the supercharger mounting posi-

tion. Temporarily cap the hose to prevent

internal hose contamination.

NOTE: Use only clean engine oil on the pipe threads. Teflon

tape or pipe sealant is not recommended as it might

loosen and cause blockage of the small oil feed ori-

fice resulting in possible supercharger failure.

Fig 3D

Fig 3E

Advertising