Vortech Universal GM LSX Tuner Kits User Manual
Page 5
P/N: 4GE020-015 v1.0, 2010-05-24
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
v
This kit should only be installed by qualified mechanics. It is imperative that
the correct air/fuel mix-
ture be maintained at all times. This kit is to be supplied to competent engine tuners for their
completion by the addition of, and tuning of, appropriate fuel and ignition control compo-
nents.
This product is intended for use on healthy, well maintained engines. Installation on a worn-out or
damaged engine is not recommended and may result in failure of the engine.
Vortech Engineering is not responsible for engine damage. Installation on new engines will not
harm or adversely affect the break-in period so long as factory break-in procedures are followed.
1. This tuner system is based on the OEM 2010 Camaro SS damper and accessory/FEAD configu-
ration. The steps and images in this instruction manual are also based upon a 2010 Camaro
installation. Your installation may require custom modifications when matched with non-2010
Camaro FEAD and vehicle components.
2. Compressor bypass valve (see parts list below), discharge, inlet and charge cooling components
are not included, but are required.
3. Pulley diameter changes: Careful size selection is mandatory for proper engine and supercharg-
er longevity. Contact the Vortech Tech Line for assistance with impeller speed calculations if nec-
essary.
The following tuner system support parts are not included as part of the system but are available
from Vortech:
A. COMPRESSOR BYPASS VALVES (REQUIRED - PICK ONE):
Contact the technical department to determine the proper valve selection for the application.
• Vortech # 8D204-010 Race Bypass Valve (SUPPORTS UP TO 600 HP)
• Vortech # 8D103-001 Mondo Race Bypass Valve (SUPPORTS UP TO 800 HP)
• Vortech # 8D003-052 Mondo Race Bypass Valve weld-on flange (aluminum)
• Vortech # 9AT200-090 Tube, aluminum Ø2.0" x specify length (for welding 8D004-052
to round tube)
• Vortech # 8D205-003 BV57 Bypass Valve (Includes V-Band Clamp and O-ring) (800+HP)
• Vortech # 8D005-051 BV57 Bypass Valve weld-on flange (aluminum)
B. CHARGE AIR COOLER / DUCTING:
• Vortech # 8N108-030: Air to Air CAC core (OEM Vortech 2010 Camaro)
• Vortech # 4GE112-030: Discharge Tube Assembly with Race Bypass Valve (OEM Vortech 2010
Camaro)
C. SUPERCHARGER PULLEYS:
(Contact technical department for proper appication match)
IMPORTANT INSTALLATION NOTES