Subaru 2010 Forester - Manual (Page 129)

Black plate (118,1)
北米Model "A8150BE-B" EDITED: 2009/ 10/ 2
3-6
Instruments and controls
& Canceling the function for
meter/gauge needle move-
ment upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the
“ON”
position.
Turn the ignition switch to the
“LOCK” or
“Acc” position.
Press the trip knob to show
“ ” or “ ”
on the odometer/trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
*: “ ” or “ ” cannot be displayed when
the ignition switch is in the “ON” posi-
tion.
To change the current setting, press the
trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. Your vehicle’s initial movement
setting of the meter/gauge needles
has been set for activation
“ ” at the
time of shipment from the factory.
. It is not possible to cancel the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the
“ON” position. Cancel the setting
when the ignition switch is in the
“LOCK” or “Acc” position.
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer/Trip meter
1) Trip knob
This meter displays the odometer and two
trip meters when the ignition switch is in
the
“ON” position.
If you press the trip knob when the ignition
switch is in the
“LOCK” or “Acc” position,
the odometer/trip meter will light up. It is
possible to switch the indications while the
odometer/trip meter is lit up. If you do not
press the trip knob within 10 seconds of
illumination of the odometer/trip meter, the
odometer/trip meter will turn off.