Subaru 2010 Forester - Manual (Page 149)

Black plate (138,1)
北米Model "A8150BE-B" EDITED: 2009/ 10/ 2
3-26
Instruments and controls
& High/low beam change (dim-
mer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light
“ ” on the combina-
tion meter is also on.
To switch back to low beam, pull the lever
back to the detent position.
& Headlight flasher
To flash the headlights, pull the lever
toward you and then release it. The high
beam will remain on for as long as you
hold the lever. The headlight flasher works
even though the light switch is in the
“OFF” position.
When the headlights are on high beam,
the high beam indicator light
“ ” on the
combination meter also illuminates.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
& Daytime running light system
(if equipped)
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the
“ ” position when it
is dark outside.
The high beam headlights will automati-
cally illuminate at reduced brightness
when the engine has started, under the
following conditions:
. The select lever is in a position other
than the
“P” position (AT models).
. The parking brake is fully released.
. The light switch is in the “OFF” or “ ”
position.
NOTE
When the light switch is in the “ ”
position, the front side marker lights,
tail lights and license plate lights are
also illuminated.