Subaru 2006 Baja - Manual (Page 107)

2-18
Keys and doors
seconds.
The alarm is triggered by:
y
Opening a door
y Turning the ignition switch to the “ON” position
y Physical impact to the vehicle, such as forced entry
(only vehicles with shock sensors (dealer option))
„ Activating and deactivating the alarm
system
To change the setting of your vehicle’s alarm system
for activation or deactivation, do the following.
1. Disarm the alarm system (see “Disarming the sys-
tem” in this section).
2. Sit in the driver’s seat and shut all doors.
3. Turn the ignition switch to the “ON” position.
4. Hold down the UNLOCK side of the driver’s power
door locking switch, open the driver’s door within the
following 1 second, and wait 10 seconds without re-
leasing the switch. The setting will then be changed as
follows:
If the system was previously activated:
The horn sounds twice, indicating that the system is
now deactivated.
If the system was previously deactivated:
The horn sounds once, indicating that the system is
now activated.
NOTE
You may have the above setting change done by
your SUBARU dealer.
„ If you have accidentally triggered the
alarm system
T To stop the alarm
Do any of the following operations:
y
Press any button on the remote transmitter.
y Cycle the ignition switch from the “LOCK” to “ON”
position three times within 5 seconds.
„ Arming the system
„
Arming the system
T To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close all doors.