Subaru 2006 Baja User Manual

Page 281

Advertising
background image

7-28

Starting and operating

matic transmission from damage.
y

The transmission does not automatically shift

up in the SPORTSHIFT mode. Perform gearshifts

in accordance with road conditions so that the ta-

chometer needle does not enter the red zone. If the

engine speed reaches a predetermined level, a

fuel-cut function will operate. Shift up if this hap-

pens.
y

If you attempt to shift down when the engine

speed is too high, i.e., when a downshift would

push the tachometer needle beyond the red zone,

beeps will be emitted to warn you that the down-

shift is not possible.
y

If you attempt to shift up when the vehicle speed

is too low, the transmission will not respond.
y

You can perform a skip-shift (for example, from

4th to 2nd or from 2nd to 4th) by operating the se-

lector lever twice in rapid succession.
y

The transmission automatically selects 1st gear

when the vehicle stops moving. It will not permit a

standing start in 2nd gear.

T Maximum speeds

When down shifting a gear, ensure that the ve-

hicle is not travelling at a speed exceeding the

Maximum Allowable Speed for the gear which

is about to be selected. Failure to observe this

precaution can lead to engine over-revving and

this in turn can result in engine damage.

In addition, sudden application of engine brak-

ing caused by downshifting when the vehicle is

travelling on a slippery surface can lead to

wheel locking; as a consequence, control of the

vehicle may be lost and the risk of an accident

increased.

The following tables show the maximum speeds that

are possible with each different gear.

When down shifting, it is important to confirm that the

current vehicle speed is not in excess of the Maximum

Allowable Speed of the gear which is about to be se-

lected.

mph (km/h)

*: SPORTSHIFT mode

Position

Turbo models

1

29 (47), 36 (58)

*

2

60 (96), 62 (100)

*

3

102 (164), 102 (164)

*

Advertising
This manual is related to the following products: