Subaru 2006 Baja - Manual (Page 153)

3-26
Instruments and controls
blades.
NOTE
y The wiper operates only when the ignition
switch is in the “ON” or “ACC” position.
y
Clean your wiper blades and window glass peri-
odically with a washer solution to prevent streak-
ing, and to remove accumulations of road salt or
road film. Keep the washer button depressed at
least for 1 second so that washer solution will be
sprinkled all over the windshield or rear window.
y
Grease, wax, insects or other material on the
windshield or the wiper blades results in jerky wip-
er operation and streaking on the glass. If you can-
not remove those streaks after operating the
washer or if the wiper operation is jerky, clean the
outer surface of the windshield or rear window
and the wiper blades using a sponge or soft cloth
with a neutral detergent or mild-abrasive cleaner.
After cleaning, rinse the window glass and wiper
blades with clean water. The glass is clean if no
beads form on the glass when you rinse with wa-
ter.
y
If you cannot eliminate the streaking even after
following this procedure, replace the wiper blades
with new ones. Refer to the “Replacement of wind-
shield wiper blades” section (chapter 11) for re-
placement instructions.
„ Windshield wiper and washer switches
„
Windshield
„
Wiper and washer switches
T Windshield wipers
1) MIST
To turn the wipers on, push the wiper control lever
down.
: Intermittent
LO: Low speed
HI: High speed
PULLL MIST
OFF
INT
LO
HI
1
UB3022BB