Dell TL2000 User Manual
User’s, Guide
Advertising
Table of contents
Document Outline
- Read this First
- Contents
- Figures
- Tables
- Safety and Environmental Notices
- Preface
- Chapter 1. Product Description
- Chapter 2. User Interfaces
- Chapter 3. Installation Planning
- Chapter 4. Installation and Configuration
- Installing Your Library
- Using the Library Configuration Form
- Choosing a Location
- Unpacking the Library
- Verifying the Shipment
- Installing the Library Foot Pads (for Desktop Installation ONLY)
- Removing and Storing the Shipping Lock
- Rackmounting the Library (for Rack Installation ONLY)
- Connecting the Host Interface Cable
- Connecting a Power Cord
- Configuring Your Library
- Choosing Your Configuration Method
- Using Factory Defaults as Your Configuration
- Configuring Your Library using the Web User Interface
- Entering Network Settings using the Operator Control Panel
- Logging on to the Web User Interface
- Verifying/Updating Firmware
- Choosing General Library Settings
- Choosing the Number of Logical Libraries for Your Library
- Entering Path Failover Feature Activation Key
- Setting Up Encryption
- Choosing Drive(s) Interface Identification/Settings
- Entering Library Network Settings
- Entering User Access Information using the Web User Interface
- Entering Date and Time using the Web User Interface
- Configuring Logs and Traces using the Web User Interface
- Entering Event Notification Information using the Web User Interface
- Running Key Path Diagnostic for Testing Encryption Configuration
- Restoring Factory Default Settings using the Web User Interface
- Logging out of the Web User Interface
- Setting the Operator Control Panel Access PIN using the Operator Control Panel
- Preparing the Host
- Verifying the Connection
- Cartridge Magazines
- Installing Your Library
- Chapter 5. Operations
- Operator Control Panel Navigation
- Operator Control Panel Menu Tree
- Web User Interface Menus
- Monitor Library Menu
- Configure Library Menu
- Configure Library: General
- Configure Library: Logical Libraries
- Configure Library: Path Failover
- Configure Library: Encryption
- Configure Library: Drives
- Configure Library: Network
- Configure Library: User Access
- Configure Library: Date & Time
- Configure Library: Logs & Traces
- Configure Library: Event Notification
- Configure Library: Restore Defaults
- Manage Library Menu
- Service Library Menu
- Import and Export Media during Normal Library Operation
- Configuring I/O Stations and Reserving Slots
- Chapter 6. Using Ultrium Media
- Chapter 7. Troubleshooting
- Chapter 8. Error Codes
- Chapter 9. Service Procedures
- Chapter 10. Check, Adjust, Remove, and Replace
- Tools Required
- Electrostatic Discharge
- Relocating Your Library
- Replacing a Tape Drive Sled
- Replacing a Power Supply
- Replacing a Library Controller Card
- Replacing Cartridge Magazines
- Replacing the Library Enclosure
- Preparing the Defective Library for Replacement
- Unpacking and Preparing the Replacement Library Enclosure
- Swapping Library Controller Cards
- Installing Your Drive(s) in the Replacement Library Enclosure
- Swapping Cartridge Magazines
- Swapping Power Supplies
- Installing the Replacement Library Enclosure
- Completing the Installation of the Replacement Library Enclosure
- Returning the Defective Library
- Appendix A. SCSI Element Types and Addresses
- Appendix B. TapeAlert Flags
- Appendix C. Sense Data
- Appendix D. Enabling LUN Support in Linux
- Appendix E. Notes on IPv6 Compatibility with Windows 2003/XP and 2008/Vista
- Appendix F. Library Configuration Form
- Notices
- Glossary
- Index