Installing the replacement library enclosure, Installing, Replacement – Dell TL2000 User Manual
Page 209: Library, Enclosure, Power, Supply, Being, Removed, From
3)
Grasp
the
top
and
bottom
edges
of
the
power
supply
and
pull
it
out
of
the
library.
b.
Install
the
power
supply
removed
from
the
defective
library
in
the
replacement
library
enclosure.
Install
the
power
supply
removed
from
the
replacement
library
enclosure
in
the
defective
library
to
return
to
Dell.
To
install
a
power
supply:
1)
Grasp
two
of
the
thumbscrews
and
push
the
power
supply
into
the
library.
2)
Tighten
the
thumbscrews.
3.
Plug
the
power
cord
into
the
replacement
library
enclosure
then
into
a
power
source.
4.
Power
ON
the
replacement
library
enclosure.
a.
If
power
ON
is
successful:
1)
The
replacement
library
enclosure
will
power
up
with
the
Ready/Activity
LED
( 1
in
ON.
2)
Power
OFF
the
replacement
library
enclosure.
3)
Unplug
the
power
cord
from
the
power
source
then
from
the
library.
4)
Proceed
to
b.
If
power
ON
is
not
successful,
contact
Technical
Support
for
further
instructions.
Installing
the
Replacement
Library
Enclosure
Refer
to
the
appropriate
procedure
in
this
section
(rack
or
desktop)
for
installing
the
replacement
library
enclosure.
Note:
If
you
are
shipping
the
replacement
library
enclosure
to
a
remote
location,
install
the
shipping
lock
and
label
before
shipment.
a66mi096
Figure
10-23.
A
power
supply
being
removed
from
a
library
Chapter
10.
Check,
Adjust,
Remove,
and
Replace
10-23