CIRCUTOR QNA500 series - Manual (Page 27)

POWER QUALITY ANALYZER QNA500 8IO
QNA500 8IO Instruction manual 27 / 111
• MODBUT/RTU (on-line communications)
• MODBUS/TCP (on-line communications)
• CIRBUS (on-line communications of the question-answer type in the ASCII format)
• ZMODEM (partial or complete file download)
• HTTP (web protocol)
• FTP (complete file download)
The previous figure shows how the WEB server of the M-BASE module can be used to program its IP
address and configure the RS-232 and RS-485 ports.
7.1.1.- IP ADDRESS CONFIGURATION
Once the equipment has been installed in an IT network with a DHCP server, the server will
automatically assign an IP address to each MULTIFIT module. The IP address of each module must be
known to communicate with them or integrate them in an IT application.
To do so, CIRCUTOR supplies the IPSetup application, which can be used to assign a specific IP
address to each MULTIFIT module.
It is vital to know the MAC address shown on the silver adhesive label attached to the top of the
product before programming this IP address.