CIRCUTOR QNA500 series - Manual (Page 37)

The following additional conditions can be assigned to each variable:
• Maximum Value
• Minimum Value
• Activation Delay (in seconds)
• Deactivation Delay (in seconds)
• Memory record (Yes/No)
• Mail Group (no, group 1, …, group 4)
Once all desired alarms have been configured, the QNA500 8IO network power quality analyzer will
permanently monitor whether the conditions of one of the programmed alarms are met or not. If this is
the case, it will generate a memory record (if programmed as such), indicating the date when the alarm
was triggered.
In addition, in case the user considers that it is important to send the notification of the alarm detected
in a different MULTIFIT module, this option can be used to perform actions on the installation, such as,
for example, closing a relay for signalling purposes.
8.12.- FACTORY PRESETS
If you wish to program the configuration values again due to an initial error, the analyzer can be
configured with the factory presets, which will load the default programming.
When this instruction is sent, the analyzer will delete the current data file and the
existing configuration will be lost. You must make sure that this process is going to be
carried out, since it does not offer the option of retrieving former values.