Doremi LE100 - Manual (Page 22)

LE1.OM.002066.DRM Page 22 of 52 Version 1.1
Doremi Labs
7
Input Feed Manager
7.1 Network Input Configuration
To set up the LE100 for live streaming from a network input, you must configure the input
settings.

Go to the Administration tab, click on the Control Panel link followed by the Input Feed
Manager link.
 Under Input Configuration, select “net0” to configure the network input.
Note:
“net0” is the default name for the network input. This can be renamed as desired.

Select the stream source (Multicast or Unicast) and the network interface to use.
o For Unicast, enter the port to listen on.
o For Multicast, enter the address and port.

Then click on the Save button (see Figure 10).

The new settings will be effective after a reboot.

If there is a stream currently available, the status section will show green for Enabled,
Signal Lock and Status. The program list will also be displayed on the right hand side of
the interface.
Figure 10: Input Configuration
– Network