Doremi LE100 - Manual (Page 24)

LE1.OM.002066.DRM Page 24 of 52 Version 1.1
Doremi Labs
7.3 Output Configuration
In order to output a transport stream from the LE100, the network output settings (multicast
address, port, and interface) must be configured.

Go to the Administration tab, click on the Control Panel link followed by the Input Feed
Manager link.
 Under Output Configuration, select “net-10” or “net-9” (depending on which output you
wish to configure) (see Figure 12).
Note:
“net-10” and “net-9” are the default names for the network ports. These can be renamed
as desired.

Enable/Disable the network output by selecting Yes or No.

Enter the multicast address and port and then select the correct Ethernet port (eth0 or
eth1).

Click on the Save button to commit the changes.
Figure 12: Output Configuration
Output
Configuration