Xilica Neutrino Series - Manual (Page 19)

Neutrino Series - Quick Start Guide
XILICA AUDIO DESIGN CANADA / ASIA / EUROPE
Pag
e
19

That completes our design example, DSP module parameter settings.
17. Save Project:
(a) Click the “Save Project” Disc located to the right of the zoom control in the Project View/Design
Mode work area to “Save Project As” or “Save” your DSP design project (each time a DSP
adjustment or change is made the Save Project Disc will reappear) OR Select “Save Project As”
under the File menu at the top left of the application to name and save your design project or
“Save Project” to save as you work.
(b) This saves the DSP design project you are working on to your PC/Computer (not to the
physical processor device). See Switch to Online Mode below to accomplish that).
(c) We recommend that you Save As the project file twice. Once to create a Master File and a
second time to create a Work File. Continue working with the Work File (or a file name of choice)
and the Master File is protected should you ever need it. At the end of the project
– continue
running the system with the Work File, rename it to Master Ver 2, or other.
18. Switch to Online Mode: (Transfer/Save DSP design project to the physical processor device)
Once your DSP design project and parameter adjustments are completed (and saved to your PC)
you can Transfer/Save your work to the connected processor device. To do this,
(a) Select the red “ Switch to Online Mode ” button (not visible if a network interface is not detected
– you are working Offline) at the top center of the Project View / Design Mode work area page –
as shown above & below on Page 20.
(b) This button selection performs two functions at the same time – it transfers or saves your DSP
design project to the connected processor device and that processor is now Online/Live.
(c) Follow Permission Instructions menu shown below carefully. Once permissions are given a
Preparing Devices. Please Wait … prompt will appear once the process begins of transferring /
saving your DSP design project to the physical processor device.
(d) Any problems – check Auto Warning Messages in Network View regarding any Firmware
Incompatibility with Software (will not load your design into device if any incompatibility).