Xtramus MCM-W V1.3 - Manual (Page 19)

2.2. Connection of UTP Cable and Optical fiber
2.2.1. 10GBASE-T (Copper Wire)
10GBASE-T uses the same RJ45 connector that is the same as original 100M/1000Mbps Ethernet
network. Just plugging the RJ45 connector into the port of 10Gbps and it is ready to work. When
connected properly, the Link/ACT LED located under the RJ45 Port will be on accordingly.
2.2.2. 10GBASE-R (Optical Fiber)
Please see the figure down below for connecting the optical fiber, transceiver, and MCM-W’s SFP+ Port.
19
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®