Xtramus MCM-W V1.3 - Manual (Page 37)

3.2. Managing MCM-W with HyperTerminal
MCM-W allows users to make system configurations and view test statistics/system information with
HyperTerminal. To access MCM-W via HyperTerminal, you have to connect MCM-W’s Diagnostic Port
with PC’s RS-232 Port via a 2.5mm Phone Jack to RS-232 cable as shown in the figure above.
The following sections will be using MCM-8S33-W as an example. Settings, installations, and
HyperTerminal commands for other MCM-Ws are quite the same and can be related.
3.3.1. HyperTerminal Settings for MCM-W
After connecting the PC’s serial port to MCM-W’s Console Port via a 2.5mm Phone Jack to RS-232
cable, please start the HyperTerminal software installed on your PC and establish connection
according to the steps listed down below.
Establishing Connection with MCM-W
1. Input a name for this connection, such as MCM-W, and also
select an icon for this connection. Click “OK” to continue.
37
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®