Xtramus MCM-W V1.3 - Manual (Page 28)

3.1.4. MCM-W Management Webpage – DDMI
DDMI (Digital Diagnostics Monitoring Interface) includes 5 parameters : Temperature (℃), Supply
Voltage (mV), Tx Bias Current (mA), Tx Power (mW) and Rx Power (mW).
DDMI (Digital Diagnostics Monitoring Interface)
Temperature (℃)
Shows the current temperature, the maximum/minimum temperature
supported and the warning maximum temperature.
Supply Voltage (mV)
Shows the current supplied voltage, the maximum/minimum supply voltage
supported and the warning maximum supply voltage.
Tx Bias Current (mA)
Shows the current Tx Bias Current, the maximum/minimum Tx Bias Current
supported and the warning maximum Tx Bias Current.
Tx Power (mW)
Shows the current Tx Power, the maximum/minimum Tx Power supported
and the warning maximum Tx Power.
Rx Power (mW)
Shows the current Rx Power, the maximum/minimum Rx Power supported
and the warning maximum Rx Power.
Note: Some transceiver can’t support DDMI function, or can only capture part of DDMI parameters,
and when this happen, the MCM-W Management Webpage will show n/a on each not captured
parameter field. Please check with your transceivers supplier if their transceiver can support or not
on capturing the DDMI parameters.
28
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®