Xtramus NuApps-QoS-RM V1.1 User Manual
Page 12
12
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES
®
Please follow the steps down below to start NuApps-QoS-RM and NuServer properly.
Starting NuServer
When starting NuApps-QoS-RM, a “Connect
to NuServer” window will pop up and asked
how you are going to connect to NuServer.
z
Local Host: Choose this option when
you-re running NuApps-QoS-RM from
NuStreams-2000i IPC module or a PC
that’s connected to NuStreams-2000i/600i
via an RJ45 cable.
z
Remote Host:
Choose this option when
you’re running NuApps-QoS-RM from
other PC located on the network. Choose
the IP address which is assigned from
NuStreams-2000i/600i from the
scroll-down menu, choose demo to enter
NuApps-QoS-RM’s Demo Mode.
z
Connect/Cancel:
Click the
Connect/Cancel button to connect to
NuStreams-2000i/600i or cancel starting
NuApps-QoS-RM.
If you choose the Local Host option, a
“NuServer-NIC Information” window will pop
up. Please select the NIC (Network Interface
Card) which is connected to
NuStreams-2000i/600i’s from the Network
Interface Information table, and click OK.
NuServer will connect to the daughter boards,
and NuApps-QoS-RM will start as well.
You now have access to NuApps-QoS-RM’s
main display window.