Xtramus NuApps-QoS-RM V1.1 - Manual (Page 13)

13
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®
Starting NuServer
If an error message window pops up and
says “Detecting NuServer System Fail”,
please close NuApps-QoS-RM and
NuServer, and start again.
After starting NuApps-QoS-RM, a Select Config window will pop up. You have to reserve ports on module
cards before performing tests with NuApps-QoS-RM. Please follow the steps down below and make the
proper configurations for NuApps-QoS-RM.
Port Reserving
As mentioned above, you have to reserve ports
on module cards before performing tests with
NuApps-QoS-RM. You can do so by either
choosing Open an Existing Configuration or by
Create a New Configuration.
If you have a previously saved configuration file
stored in your PC, you can load it and apply all
the setting you’ve made by choosing “Open an
Existing Configuration” from the Select
Config pop-up window.
Configuration files are saved in the format of
“*.xml”, and are named with Tester Name, DUT
Name, and the date/time when the files are
created.