Zilog ZAURCT - Manual (Page 21)

UM022903-0311 ZAURA System Installation and Configuration
ZAURA ™ RF Wireless Lighting Control
Installation Guide
15
• Virtual Dimming Luminaries will turn off when the Master detects a natural light level
above a certain threshold set by the light sensitivity adjustment on the Master unit.
These virtual dimming luminaries should be located near the source of the natural light.
It may take some adjustments over time to determine exactly which luminaries should
be configured for virtual dimming.
Inventory Parts and Tools
Before starting the installation process, Zilog recommends that you review the configura-
tion for each room so that the number of ZAURA Masters/Range Extenders and ZAURA
Starters match or exceed your requirements.
A typical installation can require the following items:
• ZAURA Master Unit, which includes:
– Base Plate
– Detector Body (includes circuit board)
– Lens Cover
– Retaining Screw
– CR123A Lithium Battery
– Mounting Screws

• ZAURA Starter
• ZAURA Configuration Tool (if necessary)
Required and Recommended Tools
• Phillips screwdriver (required)
• Ladder
• Pen, Pencil or Marker
• Standard electric drill and bits (for concrete, an impact drill)
• Small slot screwdriver (for changing Master DIP Switch positions)
• Tape measure
• Appropriate tools to access starter(s) in luminaries
Mount Base Plates
Before configuring the ZAURA Masters, observe the following two sections, which
describe the process for preparing Master base plate installation.