AMETEK PLA-PLW Programming Manual - Manual (Page 29)

27
Ϯ ONCE Causes the STEP to advance only one point after each trigger. Triggers that arrive
during a dwell delay are ignored
Ϯ AUTO Causes the entire STEP to be executed sequentially after the starting trigger, paced
by its dwell delays. As each dwell delay elapses, the next point is immediately executed.
Command Syntax STEP:VOLTage:STATe <NR1>
Parameters 0 | OFF(0) | 1 | ON(1) | 2 | AUTO(2) | 3 | ONCE(3)
*RST Value 0
Query Syntax STEP:VOLTage:STATe?
Returned Parameters <NR1> 0=OFF
1=ON
2=AUTO
3=ONCE