AMETEK PLA-PLW Programming Manual - Manual (Page 53)

49
Returned Parameters <AARD>
Four fields: <serial> <dhcp> <ip address> <idn string>
<serial> serial number, same as SYST:SERial?
<dhcp> assigned flag of DHCP, same as SYST:NET:DHCP?
<ip address> IP address, same as SYST:NET:ADDR?
<idn string> identification string, same as *IDN?
SYSTem:NET:SUBNet
The command sets or queries the device subnet mask.
Command Syntax SYSTem:NET:SUBNet <AARD>
Parameters <AARD> decimal dot notation.
Query Syntax SYSTem:NET:SUBNet?
Returned Parameters <AARD> string representing subnet mask.
SYSTem:RANGe
This command queries the range number for all four operational modes.
Query Syntax SYSTem:RANGe?
Returned Parameters <AARD> nn1/nn2/nn3/nn4
nn1 = range number of constant voltage
nn2 = range number of constant current
nn3 = range number of constant resistance
nn4 = range number of constant power
SYSTem:SERial?
This command queries the serial number of the main control board.
Query Syntax SYSTem:SERial?
Parameters None
Returned Parameters <CRD> SN:000B87XXXXXX
SN:000B87 = Fixed string
XXXXXX = serial number of main control board
SYSTem:SHORT:STATus?
This command queries the serial number of the main control board.
Query Syntax SYSTem:SHORt:STATus?
Parameters <NR1> Toggle on/off
0 = OFF
1 = ON
Returned Parameters <NR1> integer value representing short status state
SYSTem:VERSion?
This query returns the firmware version. The value is of the form FVX.XX, where X.XX is the revision
number.
Query Syntax SYSTem:ERSion?
Parameters None
Returned Parameters <CRD> string representing version number