AMETEK PLA-PLW Programming Manual - Manual (Page 73)

69
This command sets the slew time for positive going transitions. MINimum sets the slew to the fastest
possible time. MAXimum sets the slew to the slowest time.
Command Syntax SLEW <NRf+>
SLEW:POS <NR1>
Parameters slew time, refer to model specifications | MIN | MAX
Unit ms
Query Syntax SLEW?
SLEW? MIN SLEW? MAX
SLEW:POS?
SLEW:POS? MIN SLEW:POS? MAX
Returned Parameters <NRf+>
SLEW:BOTH <NRf+>
This command sets the slew time for all programmed changes. This command programs both positive
and negative going slew time.
Command Syntax SLEW:BOTH <NRf+>
Parameters Refer to model specifications | MIN | MAX
Unit ms
SLEW:NEG <NRf+>
This command sets the slew time for negative going transitions. MINimum sets the slew to the fastest
possible time. MAXimum sets the slew to the slowest time.
Command Syntax SLEW:NEG <NRf+>
Parameters Refer to model specifications | MIN | MAX
Unit ms
Query Syntax SLEW:NEG?
SLEW:NEG?
MIN SLEW:NEG? MAX
Returned Parameters <NRf+>
TLEV <NRf+>
This command specifies the value for the TRANsient input.
Command Syntax TLEV <NRf+>
Parameters Refer individual model specification | MIN | MAX.
Query Syntax TLEV?
TLEV? MIN TLEV? MAX
Returned Parameters <NRf+> returns the transient level.
TRAN:TWID <NRf+>
This command sets the pulse width of the transients when the generator is in PULSe mode.
Command Syntax TRAN:TWID <NRf+>
Parameters Refer to model’s specification | MAX | MIN
Unit ms
Query Syntax TRAN:TWID?
Returned Parameters <NRf+> pulse width value in ms