AMETEK PLA-PLW Programming Manual User Manual
Page 72
68
S
S
S
I
I
I
M
M
M
P
P
P
L
L
L
I
I
I
C
C
C
I
I
I
T
T
T
Y
Y
Y
C
C
C
O
O
O
M
M
M
M
M
M
A
A
A
N
N
N
D
D
D
S
S
S
The section introduces some simplicity commands that depend on current operating mode.
DUTY <NR1>
TRAN:DUTY <NR1>
This command sets the duty cycle of each of the transients when the generator is in CONTinuous
mode.
Command Syntax
DUTY <NR1>
TRAN:DUTY <NR1>
Parameters
<NR1> duty cycle value, 1 – 100.
Unit
Percentage
Query Syntax
DUTY?
DUTY?
MIN DUTY?
MAX
TRAN:DUTY?
TRAN:DUTY? MIN
TRAN:DUTY? MAX
Returned Parameters
<NR1> an integer value representing duty cycle value
FREQ <NRf>
TRAN:FREQ <NRf>
This command sets the frequency of the transients when the generator is in CONTinuous mode.
Command Syntax
FREQ <NRf+>
TRAN:FREQ <NRf+>
Parameters
<NRf+> frequency value, refer to model specifications | MIN | MAX
Unit
Hertz
Query Syntax
FREQ?
FREQ?
MIN FREQ?
MAX
TRAN:FREQ?
TRAN:FREQ?
MIN
TRAN:FREQ? MAX
Returned Parameters
<NRf+>
MLEV <NRf+>
MLEV:TRIG <NRf+>
This is an implied keyword that specifies the programmed level and whether that level is to be applied
immediately or on occurrence of a trigger.
Command Syntax
MLEV <NRf+>
MLEV:TRIG <NRf+>
Parameters
<NRf+> main level value, refer individual model specification | MIN |
MAX
Query Syntax
MLEV?
MLEV?
MIN MLEV? MAX
MLEV:TRIG?
MLEV:TRIG?
MIN MLEV:TRIG? MAX
Returned Parameters
<NRf+> main level value
SLEW[:POS] <NRf+>