Analog Way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual - Manual (Page 53)

53
- FLICKER: Choose the value of the flicker filter to
remove the flicker effect on your interlaced output
screen.
- GAMMA: Increase or decrease the gamma of your
output.
- HDCP: Enable/disable and see the HDCP status*
- OPTICAL PLUG: Enable/disable and see the opti-
cal status
Depending on the output format currently selected, all settings might not appear.
*The aim of disable the HDCP is to reduce possible problems when the chain isn’t fully HDCP compliant. By disable the output HDCP,
HDCP inputs will not be displayed anymore.
7.3.10 Input management
Once your outputs are configured, you have now to configure the inputs connected to your LiveCore™ unit.
Under the inputs section, you can view your inputs by active plugs or by all plugs (active and inactive).
7.3.10 Input management
All plugs view for 4K devices
In both cases, an AUTOSET ALL can be launched to
set up automatically your inputs.
Once the AUTOSET ALL is done, you can check each
of the inputs and see if they were well detected
using the input STATUS. The input STATUS is defined
by a FORMAT and a SIZE. If that information is not
available, your input has not been well detected or
set up.
In this case, you can manually enter into each
input settings by using the left menu: