Avery Dennison 9406 System Administrator Guide User Manual
Page 43
4.
In box B3, write the length of the field (from 1 to 30, unless
otherwise noted), based on the table below. If the bar code
uses a check digit, allow an extra character for the check
digit.
Number of
Bar Code
Characters
UPC-A
12
UPC-E
7
I 2 of 5
Variable (maximum 30 or supply size)
Code 39
Variable (maximum 30 or supply size)
Codabar
Variable (maximum 30 or supply size)
EAN-8
8
EAN-13
13
Code 128
Variable (maximum 30 or supply size)
NOTE: The length of an I 2 of 5 bar code must be even.
Also, the length of a Code 128 bar code must be
at least 2 and even. To be scannable, it must be
at least 4.
5.
Write V or F in box B4 to indicate the following.
F
Fixed length. The field will always contain the same
number of characters.
V
Variable length. The number of characters in the field
may vary.
Enter F if using UPC-A, UPC-E, EAN-8, or EAN-13 codes.
6.
Mark the corner that is on the lower left as you read the
field from left to right. This corner is the
pivot point.
NOTE: Do not include text or numbers that may appear
with the bar code when marking the lower left
corner of the field.
Desi
g
n
in
g
a
F
o
rmat
2. Designing a Format
2-29