Basler Electric IDP-800 - Manual (Page 21)

9437600990 Rev F 15
Regulation Control
Pressing the Regulation Control button accesses the Regulation Control screen (Figure 15). This screen
enables selection of the active regulation mode. The MAN/AVR button toggles between Manual and Auto
modes. When operating in AVR mode, the Off, PF, and VAR buttons can be used to enable or disable
regulation of vars or power factor. Each change to the regulation mode requires a confirmation via an
accept/reject dialog box.
The Regulation Control screen also has system status indicators and a metering display for
generator/motor and excitation system parameters.
Figure 15. Regulation Control Screen
Alarms and Status
Two screens annunciate the state of DECS alarms, functions, limiters, and relay outputs. Depending upon
the annunciation, active indicators change to amber, green, or red when active.
Pressing the Alarms/Status button of the Main View screen displays the Alarms and Status screen (Figure
16). This screen has indicators for alarms, limiter states, and DECS functions/conditions. An Alarms
Reset button can be pressed to clear alarm annunciations. (An alarm cannot be reset unless the condition
causing the alarm has been cleared.) Pressing the History button accesses the Alarms History screen
which lists the alarms captured by the DECS. Buttons are provided for scrolling through the alarms list,
clearing selected alarms, and clearing all listed alarms. A
USB button enables the transfer of selected
alarm records to a memory device plugged into the IDP-800 USB port.
IDP-800 IDP-800-A Operation