Basler Electric IDP-800 - Manual (Page 55)

9437600990 Rev F 49
Mounting
IDP-800 mounting consists of selecting a suitable mounting location, cutting the panel opening, and
securing the display to the panel.
Warning!
The control panel/equipment enclosure where the IDP-800 will be
installed must be removed from service and all related operating and
control power de-energized before proceeding with IDP-800
installation.
Mounting Considerations
The IDP-800 is intended for mounting in a cutout on a vertical panel in an environment where the ambient
temperature does not exceed the temperature range of 0 to 50
°C (32 to 122°F). Observe the following
considerations and guidelines when preparing to mount the IDP-800.
Location and Environmental Considerations
The IDP-800 is intended for mounting in a vertical panel. If mounting the IDP-800 in a slanted panel, the
panel should not deviate more than thirty degrees from vertical. If the panel slants more than thirty
degrees, you must ensure that the ambient temperature surrounding the IDP-800 does not exceed 40
°C
(104
°F). This may require the use of external cooling equipment (such as a fan or air conditioner). To
enhance ventilation and maintenance, the IDP-800 should be installed no closer than 4 inches (10
centimeters) from adjacent equipment. Heat created by nearby equipment must not cause the ambient
temperature surrounding the IDP-800 to exceed its maximum operating temperature.
Mounting Panel Thickness
The IDP-800 can be mounted on a panel with a thickness no less than 0.06 inches (1.6 millimeters) and
no more than 0.39 inches (10.0 millimeters).
Cutting the Panel Opening
Cut an opening in the mounting panel
that is 8.05 inches (205 millimeters)
wide and 6.28 inches (160 millimeters)
high. Figure 57 illustrates the panel
cutting dimensions.
Figure 57. IDP-800 Panel Cutting Dimensions
IDP-800 Mounting