Beisler 1225-4 - Manual (Page 17)

1-15
This is how to change a tape roll:
1. Pull off the right-handed holding disc (11).
2. Press on the fixing screw of the adhesion tape holder and swing it to the
front and to the right.
3. Remove the core of the empty adhesion tape roll (10) and remove the
carrying paper (9) completely from the separation slit (4).
4. Insert a new adhesion tape roll (10) and press the right-handed holding
disc (11) on the pole until it is engaged.
5. Lift a piece of the adhesion tape (8) from the carrying paper (9) and insert
the carrying paper into the separation slit (4).
6. Swing the adhesion tape holder to the left until the fixing screw is enga-
ged.
7. Cut the adhesion tape behind the adhesion tape holder.
5.2 Working table
The working table is used for the alignment of the trouser parts to be sewed.
Above it you can see two prelaying tables, where you can stock the fabrics.
The Mains- / Emergency-Stop-Switch is located below the working table.
5.3 Operation device
The machine can be operated during production using the operation device.
You can load existing programs and program new ones.
1 Display
2 Cursor keys
3 Key for stacking manually
4 Special key
5 Minus / Plus keys
6 Reset key
1
2
3
4
5
6