Beisler 1225-4 - Manual (Page 37)

2-11
Inp. Connector occupation Input connector
M1 Reset key B 2-4
M2 Stacking manually B 4-6
M3 Lining clamp B 8-10
M4 Adhesion stamp B 10-12
M8 Photocell at prelaying table Pin 19-, Pin 20+, Pin 3 Signal
All outputs are valves and occupied as follows:
Valve Connector occupation Output connector
Y0 - Sewing foot up A - 1
F2 Y2 - Table blowing A - 3
F3 Y3 - Contour guiding A - 5
F3 Y13 - Dirt suction A - 5
F4 Y4 - Lift contour roll A - 7
F5 Y5 - Kett-up A - 9
F6 Y6 - Holding stamp A - 11
F7 Y7 - Stacker impulse A - 13
F8 Y8 - Swing-out device A - 15
F9 Y9 - Swing blade A - 17
F10 Y10 - Top transport A - 18
F11 Y11 - Adhesion stamp A - 16
F12 Y12 - Lining clamp and tape advance A - 14
Hint
The output „Sewing foot up“ (Y0) cannot be programmed on setup page -10
and can be enabled on setup page -03 (see there).
3.7 Program inputs and outputs
The inputs and outputs can be enabled/disabled on setup page -10. Enabled
inputs and outputs can be programmed.
To program an input or output, position the cursor on the respective icon and
press the Special key. The setup page will be opened.
Hint
The programming of inputs and outputs is not executed program-specific.
The setting is the same for all programs. Modifications effect all sewing
programs.
3.7.1 Setup page of inputs and outputs
O U T F 6
P R G
S T E P S T O P
0 1 0 0