Beisler 1265-5 - Manual (Page 105)

3.2 A djusting the contourguide
C aution:R isk ofinjury!
S w itch the m ain sw itch off.
A djustthe contourguide only w ith the sew ing unitsw itched off.
1.Q uick adjustm entofheight
The rough setting ofthe m aterialthickness is setand read offatthe
setting w heel2.4 steps are available.
Step 1 = 0.8 m m
Step 2 = 1.6 m m
Step 3 = 2.4 m m
Step 4 = 3.2 m m
– S etthe desired m aterialthickness atthe setting w heel2.
2.Fine adjustm entofheight
The presetting via the quick adjustm entofheight2 is readjusted by the
fine adjustm entofheight1.
S tandard
The sliding plate 3 ofthe contourguide should be low ered as m uch as
possible.The fabric should slide underneath the sliding plate as easily
as possible.
– P ush the fabric underthe sliding plate.
– A ctuate outputY 3 to low erthe sliding plate.
– Turn the setting screw 1 counter-clockw ise untilthe sliding plate
rests on the fabric.
– C heck w hetherthe fabric is easy-gliding.Forthis purpose guide
the fabric underneath the sliding plate.
30
1
2
3