Beisler 1710-5 - Manual (Page 19)

1-17
6 Operation of the Machine
6.1 Production sequence
The ‘Fly Piece Unit, Series 1710/2’ works semi-automatic with high production
speed. The operator of the machine has to:
• select the desired sewing program;
• align the fly pieces correctly;
• start the sewing process by pressing the start button;
• supervise the fault-free functioning of the machine.
The following steps can be distinguished within the production sequence:
1. Align the fly piece at the stop bar beneath the transportation belt.
2. Press the start button to initiate the sewing process.#
3. The transportation belt will be lowered and pushes fly piece, zipper and
back-up tape under the sewing foot. When switching dark, the photo
cell gives the command for the start of the sewing.
4. When the fly piece left the range of the transportation belt, this will be
lifted and the next fly piece can be aligned.
5. After the fly piece has been sewed, zipper and back-up tape will be cut
and the fly piece is stacked in the magacine.
6.2 Alignment of the Fly Piece
1
2
3
Push the fly piece from the front below the transportation belt (1) until it
touches the rear stop (2). The left-handed end of the fly piece must be est. 1
cm away from the sewing foot.
When the fly piece is positioned correctly, press the start button (3) to start
the sewing process.