Beisler 1710-5 - Manual (Page 32)

2-10
Hint
If the presser foot cannot be enabled, you will first have to switch off Output F1
on Setup page -10. More information is given further below.
(max)
30V 15 V
120 00 100 [ms]
SETUP-02
1. Position the cursor on the time for maximum power (lower line, left-handed
value) and press the Plus/Minus key, until 100 ms is set. This assures that
the presser foot is lifted safely after the end of the seam.
2. Position the cursor on the value of the holding voltage (upper row, middle
value) and press the Plus/Minus key until 15 V is set. This assures that
the magnetic valve for the foot lifting cannot be overloaded.
3. Position the cursor on the right side on the value of the start delay and
enter 120 ms. This time is needed that the presser foot is safely on the
fabrics before sewing starts.
4. Position the cursor on both presser foot icons and set them to „Presser
foot down“ (like shown in the drawing).
5. Press the Special key to leave this page.
6. Check whether the presser foot is programmed on „up“ on page „PROG
000“, too:
PROG.
000
: 4200