Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 15)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas OM MN-1017EN 9
Figure 2-3. Removing the Turner Assembly.
d. Lift out the turner assembly. See Figure
2-3.
e. To reassemble, reverse this procedure.
7. Remove the drop plate at the infeed end of
the conveyor by lifting the forward end and
sliding it toward the rear of the conveyor.
(See Figure 2-4.) Wipe it clean with a damp
cloth. Do not clean the drop plate with an
abrasive cleaner, as doing so will cause
donuts to stick to it.
Figure 2-4. Removing the Drop Plate.
8. After the shortening has drained off of the
conveyor assembly, set the conveyor
assembly aside.
9. Check again to see that the shortening in the
kettle has cooled to 100 °F/38°C.
10. Remove the shortening from the kettle using
one of these methods:
• Use an optional Filter Flo Siphon to
siphon the shortening into one or more
large metal buckets. (See the
instructions in Section 4.) Be careful not
to disturb the sediment that has
accumulated in the bottom of the kettle.
• Tilt the control box assembly back,
raising the thermostat and high limit out
of the kettle. Lift the kettle out of the
fryer case and carefully pour the
shortening into one or more large metal
buckets. Be careful not to disturb the
sediment that has accumulated in the
bottom of the kettle.