Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 23)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas OM MN-1017EN 17
Roto Cooler
SPECIFICATIONS
Dimensions Shipping
Weight
Electrical Data Construction Standard
Equipment
Dia.=24”/61 cm
H=6-5/8”/17 cm
16 lb/7.3 kg 120 V
1 Phase
50 or 60 Hz
Basket: High-density
polyethylene. Base:
Spun, polished,
heavy-gauge
aluminum. Basket and turntable
base with power cord
and motor.
Figure 4-2. Roto Cooler.
The Roto Cooler is designed to catch and cool
donuts as they drop from the outfeed end of the
Donut Robot. It is meant to be used on a flat,
stationary table or countertop. The operator is
expected to read and follow these instructions.
To use the Roto Cooler:
1. Place the Roto Cooler near the outfeed end
of the Donut Robot so donuts will fall into
it.
2. Connect the Roto Cooler power cord to the
120 V outlet on back of the Donut Robot’s
heater head.
3. Turn on the Roto Cooler. It will rotate and
receive donuts. Remove cooled donuts from
the Roto Cooler as needed.
4. When you are finished using the Roto
Cooler, turn it off and unplug it.
WARNING
To avoid electrocuting yourself or
damaging the machine, never submerge the
base of the Roto Cooler.
5. Clean the Roto Cooler using soap and water
and a non-abrasive cloth or scrubber.
On the following pages are a wiring diagram and
a parts list for the Roto Cooler.
FIGURE 4-3. ROTO COOLER MAIN ASSEMBLY.