Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 28)

Belshaw Bros., Inc. www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
22 MN-1017EN Donut Robot Mark II-Gas OM
Filter Flo Siphon
SPECIFICATIONS
Dimensions Shipping Weight Construction Standard Equipment
H=16”/41 cm
Dia.=6-1/4”/16
cm
3 lb/1.4 kg Siphon tube and valve: nickel-plated
steel. Handle: wood. Filter ring:
powder-coated. Filters: flannel.
Mounting brackets: aluminum alloy. Siphon assembly
including valve, filter,
filter ring, and clamp.
Figure 4-7. Filter Flo Siphon.
The Filter Flo Siphon is designed to drain and
filter shortening from the kettle of the Donut
Robot. The operator is expected to read and
follow these instructions.
Installation
1. Let the shortening cool to 100 °F/38°C.
WARNING
Hot shortening can cause serious burns.
Never touch hot shortening. Never wear
shorts while using the Filter Flo Siphon.
2. Place the mounting bracket, with the siphon
tube in it, on the lip of the kettle. You may
place it on the infeed end of the kettle, or on
the front side of the kettle. If you place it on
the front side, you must disconnect the
swing connecting rod from the throw arm
and move it out of the way.
3. Position the opening of the siphon tube near
the bottom of the kettle.
4. Tighten the thumb screw in the mounting
bracket.
BULB
DR42-0273
MOUNTING
BRACKET
DR42-0274
HANDLE
SF100-0027
SIPHON TUBE
DR42-0626
FILTER
MOUNTING
BRACKET
DR42-0276
FILTER RING
DR42-0275
VALVE
DR42-0627
FILTER
DR42-0277