Belshaw Adamatic Mark II-Gas Donut Robot User Manual
Page 55
Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas TS
MN-1018EN
15
THE CUTTER CUTS DOUBLE WHEN YOU HAVE SELECTED ONE CUT PER
POCKET CONTINUED.
Possible Causes
What To Do
An internal wire is interfering with the nylon
brake dog.
Move the wire.
The arm on the cutter head microswitch is bent.
Bend the arm back into position or replace the
microswitch.
The wires on the cutter head microswitch are
reversed.
Make the correct connections.
THE CUTTER WILL NOT OPERATE, BUT THE CONVEYOR RUNS.
Possible Causes
What To Do
The cutter head power cord is not plugged in to
the outlet on the back of the control box.
Connect the cutter head power cord to the correct
outlet.
WARNING
To avoid being burned, electrocuted, or otherwise
injured, before doing any of the following, turn off
the machine, allow the shortening to cool, and
disconnect the machine from the power source.
The set screws in the cutter head cam are loose.
Tighten the set screws.
The cutter head power cord is broken.
Repair or replace the cutter head power cord.
The cutter motor is defective.
Replace the cutter motor.
One of the microswitches is defective. (There are
three microswitches in the conveyor drive assy.
and one microswitch in the cutter head.)
For help in testing the microswitches, refer to Section
4, “Electrical Components.” Replace any defective
microswitches.
The cutter head power switch is defective.
Replace the cutter head power switch.
The circuit breaker on the back of the heater head
is defective.
Replace the circuit breaker.
The cutter head assy. wiring harness is not
connected.
Check the connection between the pin housing in the
conveyor drive assembly and the socket housing in
the heater head. Also, make sure that the pins are
securely seated in the pin housing.
The cuts-per-pocket switch is defective.
Replace the cuts-per-pocket switch.