Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 31)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas OM MN-1017EN 25
Shortening Reserve Tank
SPECIFICATIONS
Dimensions Shipping
Weight
Capacity Construction Standard
Equipment
L=11”/28 cm
W=5-1/2”/14 cm
D=4”/10 cm
4 lb/2 kg 4 lb/2 kg
shortening
Nickel-plated steel
tank and non-
corrosive self-closing
valve. Shortening reserve
tank and valve
assembly.
The Shortening Reserve Tank is designed to
supply melted shortening to the kettle of the
Donut Robot. The operator is expected to read
and follow these instructions.
To use the Shortening Reserve Tank:
1. Position the Shortening Reserve Tank on the
conveyor side panels. Make sure that you
do not position it above the donut turner.
WARNING
Be careful if you put hot shortening into
the tank. Hot shortening can cause serious
burns.
2. Place shortening in the tank.
3. Turn on the Donut Robot. The heat of the
fryer will melt the shortening in the tank.
4. To supply shortening to the fryer, open the
valve by pushing down on the valve
assembly.
5. When you are done making donuts, drain the
remaining shortening into the fryer.
6. When the shortening and equipment have
cooled completely, remove the Shortening
Reserve Tank and wash it.