Maintenance and cleaning – Belshaw Adamatic Mark II-Gas Donut Robot User Manual
Page 22
Belshaw Bros., Inc. www.belshaw.com
• Phone 206-322-5474 • Fax 206-322-5425
16
MN-1017EN
Donut Robot Mark II-Gas OM
CAUTION
To avoid damaging the machine, never use
force to assemble or operate the Feed
Table.
Maintenance and Cleaning
After Each Use
Use a soft, damp cloth for cleaning.
WARNING
To avoid electrocuting yourself or
damaging the machine, never allow any
liquid to enter the power head.
As Needed
If you ever need to adjust the tension of the
conveyor chains, follow these steps:
1. Loosen the hex head bolts that hold the
roller shaft at the outfeed end of the
conveyor.
2. Pull the shaft until the chains reach the
correct tension. The tension is correct when
you can lift the chains about 1”/2.5 cm
above the surface of the Feed Table. Each
chain should have the same tension.
3. Tighten the hex head bolts that hold the
roller shaft.