Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 25)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark II-Gas OM MN-1017EN 19
Icing Finishing Tree and Roto Cooler
SPECIFICATIONS
Dimensions Shipping
Weight
Electrical Data Construction Standard
Equipment
Dia.=24”/61 cm
H=32”/81 cm
28 lb/12.7 kg 120 V
1 Phase
50 or 60 Hz
Trays: Heavy-gauge
aluminum. Basket:
High-density
polyethylene. Base:
Spun, polished,
heavy-gauge
aluminum. Power turntable and
four trays, three of
which have dividers.
Figure A-4. Icing Finishing Tree and Roto
Cooler.
The Roto Cooler is designed to catch and cool
donuts as they drop from the outfeed end of the
Donut Robot. It is meant to be used on a flat,
stationary table or countertop.
The Icing Finishing Tree, which mounts on the
Roto Cooler, is designed to hold toppings in
which donuts can be dipped. The operator is
expected to read and follow these instructions.
To use the Roto Cooler and the Icing Finishing
Tree:
1. Attach the Icing Finishing Tree to the Roto
Cooler. Fill the metal trays with toppings.
2. Install and operate the Roto Cooler as
explained in the previous section.
3. Decorate the donuts with the toppings in the
trays.
4. When you are finished using the Roto
Cooler and the Icing Finishing Tree, turn off
the Roto Cooler and unplug it.
WARNING
To avoid electrocuting yourself or
damaging the machine, never submerge the
base of the Roto Cooler.
5. Clean the trays of the Roto Cooler and the
Icing Finishing Tree using soap and water
and a non-abrasive cloth or scrubber.
On the following page is a parts illustration for
the Icing Finishing Tree.