Belshaw Adamatic Mark II-Gas Donut Robot - Manual (Page 6)

Belshaw Bros., Inc. www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
iv MN-1017EN Donut Robot Mark II-Gas OM
Preface
The Donut Robot Mark II-Gas is designed to
automatically cut and fry cake donut products,
and to fry yeast-raised donut products. It is not
designed to cut or fry any other products. The
Mark II Gas is available for LP Gas and Natural
Gas in the following electrical configurations:
• 120 volts, 1 phase, 50/60 hertz
The Mark II-Gas is designed to be used on a flat,
stationary table or countertop, with the operator
standing opposite the control box and flue stack
of the machine. The operator must work safely
at all times and read this manual and follow its
instructions and warnings. Study the instructions
and warnings in this manual carefully. A
thorough understanding of how to install,
maintain, and safely operate the Donut Robot
Mark II-Gas will prevent production delays and
injuries.
The Mark II Gas produces only 71.5 dB(A) of
equivalent A-weighted sound pressure at
workstations. This has been determined during a
dry run of the machine, using a Bruel & Kjaer
sound level meter, type 2236.
To use the Mark II-Gas safely, heed the
following warnings and all other warnings that
appear in this manual:
• Make sure the machine is secured to the work
surface. Doing so will prevent the machine
from moving or falling, which could cause
serious injury.
• Never let water and hot shortening come in
contact with each other. Moisture causes hot
shortening to spatter, which may cause
serious burns.
• Do not overfill the kettle with shortening. If
shortening overflows the kettle, it could
cause serious burns or could cause someone
to slip on the floor and be seriously injured.
• To avoid electrocution or other injury,
unplug the machine before attempting any
adjustment, repair, disassembly, or cleaning.
• Hot shortening can cause serious burns.
Make sure that the system and the shortening
are cool before attempting any adjustment,
repair, disassembly, or cleaning.
• To avoid damaging the machine, never use
force to assemble, disassemble, operate,
clean, or maintain it.
• Be careful never to get shortening, water, or
other materials on the floor. If anything does
get spilled on the floor, mop it up
immediately. Materials on the floor can
cause people to slip or fall, resulting in
serious injury or loss of life.
• To prevent unintentional startup and possible
fire, unplug the machine if there is a local
power outage. When the power is restored, it
is safe to plug the machine in again.
• To avoid fire and personal injury, always
shut the machine down completely and wait
at least five minutes before igniting the pilot
again.
• To avoid electrocution, make sure that all
electrical cords are not frayed or cracked and
that they do not pass through any water or
shortening.
• Make sure that all electrical cords are routed
so that no one will trip over them.
• To avoid serious injury or death, always keep
the fryer area free and clear from
combustible materials.